직매형 마이크로 덕트 커넥터

TECHNICAL DETAILS

Published product facts

			구성 요소
			본체		폴리카보네이트
			세탁기		폴리아세탈
			칼라		폴리아세탈
			바다표범		NBR
			집게 발톱 잠금		SS301/304
			소매		폴리아세탈
피트 튜브
파이프 재질			HDPE、PE、Nylon、Polyurethane
파이프 외경			Φ3,Φ4,Φ5,Φ6,Φ7,Φ8,Φ10,Φ12,Φ16,Φ18,Φ20
Technical Parameter
유체 다루기			공기
조임			0.15~0.8MPa 누설 없음
인장 시험			400N
내압시험 압력			2.5MPa
작동 압력 범위			0~1.6MPa
주위 온도와 유체 온도			-40~60℃
설치 온도			-10℃/+50℃
권장 불어내기 온도			-15℃/+35℃
보호 등급			IP68
자외선 차단 등급			F1
삽입력			50N 최대(5kg)
수명			25년
표준			EN 50411-2-8
사양 및 치수
ANMASPC 코드		덕트 외경(mm)		개/봉		파이프 규격
DB07/3.5		Φ7/3.5		10.0		Φ7
DB08/3.5		Φ8/3.5		10.0		Φ8
DB10/6		Φ10/6		10.0		Φ10
DB12/8		Φ12/8		10.0		Φ12
DB14/10		Φ14/10		10.0		Φ14

SELECTION GUIDE

Selecting a direct-buried microduct coupler

Use these checkpoints to prepare a product-specific enquiry and close the fit, test and documentation questions before ordering.

1. Match the ductProvide the duct outside diameter, inside diameter and wall condition; the source lists thick-walled DB use.
2. Confirm the routeState direct-buried depth, chamber or entry location and the expected environmental conditions.
3. Set the test boundaryCompare the supplier-stated above-25-bar resistance and –40 to 65°C range with the project test plan.
4. Request the codeAsk for the matching DB article code, drawing, current standard evidence, quantity and packing confirmation.

자주 묻는 질문

자주 묻는 질문

What is a straight bury microduct connector used for?

It joins thick-walled microducts in a direct-buried telecom route, where the joint must remain in place after installation.

How do I choose a DB microduct coupler size?

Send the measured duct outside and inside diameter and request the matching DB article code, such as the published DB07/3.5 to DB14/10 examples.

What pressure can this direct-buried connector handle?

The supplier states high-pressure resistance above 25 bar. Request the exact test method and confirm the project operating pressure before treating it as a design limit.

What temperature range is published for the connector?

The supplier states temperature resistance from –40 to 65°C. Confirm whether those conditions match the installed route and the required test evidence.

Can the connector be disconnected after installation?

The source describes a permanent connection that cannot be unlocked after installation. Plan the joint location and inspection before fitting.

Does the connector comply with EN 50411-2-8?

The supplier page states EN 50411-2-8. Request the current test or compliance document for the selected DB model if it is required for the project.